Book123

    Free register and download UseNet downloader, then you can FREE Download from UseNet.

    Download without Limit " Free PDF: Z-Wave enabled 3-Way 600 Watt In-Wall Dimmer Switch User Manual " from UseNet for FREE!

3-Way switch applications may require an additional wire to be run, refer to the wiring diagrams for further instruction & 8230; For 2, 3, and 4 switch, and multi-WAY apllications & 8230; 1 Z-Wave® enabled 3-Way 600 Watt In-Wall Dimmer Switch User Manual For Model HA14WD Thank you for purchasing the Z-Wave ® Enabled 3-Way 600 Watt In-Wall Dimmer Switch. Z-Wave ® products by Wayne-Dalton allow you to manage and control your home by remote control for convenience, comfort, safety and energy conservation. Your Z-Wave ® Enabled & 8230;

Installation 3. Trim wires to 7/16 inch as shown in the adjacent diagram. Installation (continued) 4. Connect the BLACK wire of the HA14WD switch to the 120V Hot building wire (the wire leading to the circuit breaker or fuse box,) using a twist connector (provided.) note: Insert wires straight into the twist connector, the twist clockwise. Make sure all twist connectors are tight. Secure each twist connector with electrical tape. Verify no bare wire shows below the wire connector. 5A. For SInGLe poLe AppLICAtIon onLY: Connect the BLUe wire of the HA14WD to the LoAD wire using a twist connector (provided.) 5B. For 2, 3, and 4 SWItCH, and MULtI-WAY AppLICAtIonS: Connect the BLUe wire of the HA14WD to the LoAD wire of the lighting load using a twist connector provided. note: An additional wire run may be necessary in multi-switch applications to connect the HA14WD directly to the lighting load as shown in the wiring diagrams. Consult with a qualified electrician if you are unsure about any part of the installation. 6. Connect the ground wire from the box to the bare copper wire on the HA14WD switch. If there is no ground wire, connect the bare copper wire of the HA14WD to the wall box if it is metal. If the wall box is plastic, connect the bare copper wire to ground as supplied or consult with a qualified electrician. 7A. For SInGLe poLe AppLICAtIon onLY: Remove the semi-stripped end of the reD wire and apply the twist connector to this wire without any connecting wire. 7B. For 2, 3, and 4 SWItCH, and MULtI-WAY AppLICAtIonS: Connect the reD wire to the COMMON wire (aka traveler) of the next switch in the circuit. 8. Tuck wires into wall box leaving room for the HA14WD unit. For testing purposes, partially screw mounting screws (provided) of the HA14WD into the wall box. 9. Restore electrical power to the circuit. note: Before operating the switch, be sure the air-gap switch (small slide switch located below the rocker switch) is in the ON position. The switch is in the ON position if the vertical line (ON symbol) is visible to the left of the air-gap switch. note: When changing a light bulb, slide the air-gap switch to the OFF position. The OFF position is indicated if there is an & 8220;O& 8221; (OFF symbol) visible to the left of the air-gap switch. This disconnects electrical power to the light fixture to prevent an electrical shock. When the bulb has been replaced, slide the switch back to the ON position. INSTALLATION INSTRUCTIONS CONTINUED ON NEXT PAGE& 8230; ON Indicator OFF Indicator

Buy It at Lowest Price on Amazon

Z-Wave enabled 3-Way 600 Watt In-Wall Dimmer Switch User Manual.Pdf

Rating:
2.5 out of 5 by Book123