Book123

    Free register and download UseNet downloader, then you can FREE Download from UseNet.

    Download without Limit " Free PDF: SL-6107 Motion Sensing 3-Way Wall Switch " from UseNet for FREE!

& 8230; wiring later, mark the house wiring with tape indicating where the wire had been connected. In the following section you will install a jumper wire at one 3-way switch & 8230; 3-WAY SWITCH & 8230; SL-6107© 2007 HeathCo LLC 595-4514-15 The Heath®/Zenith Motion Sensing 3-Way Wall Switch automatically controls indoor lighting:• In AUTO mode, the control automatically turns the light on when you enter the room. The length of time the light stays on is adjustable. The Heath®/Zenith SL-6107 Motion Sensing 3-Way Wall Switch replaces any & 8220;3- & 8230;

Some local building codes may require installation by a qualified electrician. inStaLLation For your safety, turn off power at the fuse or circuit breaker. Note: A & 8220;3-way& 8221; circuit controls lights from two separate switches. If you want to use this product in a single switch circuit or if you want to install more than one motion sensing wall switch, see Special Installations, page 8. ? Select a 3-way circuit that controls a light or an outlet to a lamp. Total lighting must be from 25 to 500 watts incandescent, or 60 to 400 watts fluorescent using a rapid start ballast. Note: May not be used to operate electronic or magnetic ballasts. Less wattage than the minimum may not allow the control to work properly. The switch selected for replacement should be in a place that can detect motion in the desired area. ? For easier re-wiring later, mark the house wiring with tape indicating where the wire had been connected. In the following section you will install a jumper wire at one 3-way switch and replace the other switch with the SL-6107. * Note: The existing 3-way switch will be referred to as the & 8220;Remote Switch& 8221; throughout the rest of the installation manual. -3- 595-4514-15 inSta LLation SL-6107 SWITCH 1ST IN CIRCUIT WHITE FROM POWER SOURCE BLACK BLACK WHITE RED (In Wall) BROWN BLACK EXISTING 3-WAY SWITCH ADD JUMPER WIRE SL-6107 RED (From 6107) WHITE BLACK *COMMON ONE SL-6107 SWITCH IN CIRCUIT WHITE FROM POWER SOURCE BLACK WHITE BLACK WHITE BLACK *COMMON *COMMON SL-6107 SWITCH 2ND IN CIRCUIT WHITE FROM POWER SOURCE BLACK BLACK WHITE RED (In Wall) BROWN BLACK EXISTING 3-WAY SWITCH ADD JUMPER WIRE SL-6107 RED (From 6107) WHITE BLACK *COMMON RED (In Wall) *COMMON-Used for illustrative Purposes Only. Check Your Switch. The common may be in a different location, depending on the brand of your switch. RED is used to represent the second wire between two standard three-way switches. This may not be the color used in all installation. If you are not sure about your wiring, call an electrician for installation help. There is also a RED wire on the SL-6107 switch. Check the instructions above closely and do not confuse the two. See pages 4 through 6 for detailed instructions for installing and

Buy It at Lowest Price on Amazon

Motion Sensing 3-Way Wall Switch.Pdf

Rating:
2.5 out of 5 by Book123