Book123

    Free register and download UseNet downloader, then you can FREE Download from UseNet.

    Download without Limit " Free PDF: QoS on Wireless LAN Controllers and Lightweight APs Configuration Example " from UseNet for FREE!

& 8230; Unified Wireless network using Cisco Wireless LAN & 8230; Cisco AVVID 802.1p UP-Based Traffic Type Cisco AVVID & 8230; This is covered in the Cisco Unified Wireless IP Phone 7920 Design and & 8230; QoS on Wireless LAN Controllers and Lightweight APs Configuration Example Document ID: 81831 Introduction Prerequisites Requirements Components Used Conventions Background Information Layer 3 QoS Packet Marking Enhancements Network Setup Configure Configure the Wireless Network for QoS Configure the Wired Network for QoS & 8230;

Introduction This document provides a configuration example that shows how to configure Quality of Service (QoS) in Cisco Unified Wireless network using Cisco Wireless LAN Controllers (WLCs) and Lightweight Access Points (LAPs). Prerequisites Requirements Ensure that you meet these requirements before you attempt this configuration: Basic knowledge of the configuration of LAPs and Cisco WLCs • Knowledge of how to configure basic routing and QoS in a wired network • Components Used The information in this document is based on these software and hardware versions: Cisco 2006 WLC that runs firmware release 4.0 • Cisco 1000 Series LAPs • Cisco 802.11a/b/g Wireless Client Adapter that runs firmware release 2.6 • Cisco 3725 Router that runs Cisco IOS® Software Release 12.3(4)T1 • Cisco 3640 Router that runs Cisco IOS Software Release 12.2(26) • Two Cisco 3500 XL Series Switches that run Cisco IOS Software Release 12.0(5)WC3b • The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command. & 8230; In the past, WLANs were mainly used to transport low-bandwidth, data-application traffic. Currently, with the expansion of WLANs into vertical (such as retail, finance, and education) and enterprise environments, WLANs are used to transport high-bandwidth data applications in conjunction with time-sensitive, multimedia applications. This requirement led to the necessity for wireless QoS. The IEEE 802.11e working group within the IEEE 802.11 standards committee has completed the standard definition. However, the adoption of the 802.11e standard is in its early stages, and as with many standards there are many optional components. Just as what occurred with 802.11 security in 802.11i, industry groups such as the Wi-Fi Alliance, and industry leaders such as Cisco are defining the key requirements in WLAN QoS through their Wi-Fi MultiMedia (WMM) and Cisco Compatible Extensions (CCX) programs. This ensures the delivery of key features and interoperation through their certification programs. Cisco Unified Wireless Products support WMM, a QoS system based on the IEEE 802.11e draft that has been published by the Wi-Fi Alliance. The controller supports four QoS levels: Platinum/VoiceEnsures a high quality of service for voice over wireless. • Gold/VideoSupports high-quality video applications. • Silver/Best EffortSupports normal bandwidth for clients. This is the default setting. • Bronze/BackgroundProvides the lowest bandwidth for guest services.

Buy It at Lowest Price on Amazon

QoS on Wireless LAN Controllers and Lightweight APs Configuration Example.Pdf

Rating:
2.5 out of 5 by Book123