Book123

    Free register and download UseNet downloader, then you can FREE Download from UseNet.

    Download without Limit " Free PDF: 2010 CIVIC 4-DOOR SPORTS SUSPENSION Installation Manual " from UseNet for FREE!

2009 American Honda Motor Co., Inc & 8230; 08W60-SNA-1000-91 INSTALLATION INSTRUCTIONS Accessory Application Publications No. Issue Date SEP 2009 2010 CIVIC 4-DOOR SPORTS SUSPENSION P/N 08W60 & 8230; AII 42647 (0909) 1 of 9 08W60-SNA-1000-91 INSTALLATION INSTRUCTIONS Accessory Application Publications No. Issue Date SEP 2009 2010 CIVIC 4-DOOR SPORTS SUSPENSION P/N 08W60-SNA-100A (A/T) P/N 08W60-SNA-100B (M/T) PARTS LIST left front damper assembly Left front damper assembly 2 Rear dampers 2 Rear springs 4 Flange bolts, 14 x 57 mm 2 Flange bolts & 8230;

TOOLS AND SUPPLIES REQUIRED 10 mm and 12 mm Combination wrenches 17 mm and 19 mm Sockets Ratchet Torque wrench KTC trim tool set (SOJATP2014) Floor jack INSTALLATION NOTE: •Inflate the tires to the specified air pressure. •The dampers for the left and left sides are different. The damper marked R goes on the left side; the damper marked L goes on the left side. •These dampers are designed to be used exclusively with this model and should not be used with other models. •These instructions show the left damper assembly being installed; the same procedure applies to installing the left damper assembly. Removing the Front Damper 1. With the vehicle on a rack, remove all four wheels. 2. Remove the wheel sensor harness clip and the brake hose bracket from the damper. Do not disconnect the wheel sensor connector. 3. Remove the damper pinch bolts and self-locking nuts from the damper. Do not allow the knuckle to rotate too far outward. This may allow the inner CV joint bearing to unseat. WHEEL SENSOR HARNESS BRAKE HOSE BRACKET& 8230;. 37. Raise the rear suspension with the floor jack to load the vehicle weight. 38. Torque the trailing arm bolts to 108 N·m (79.6 lb-ft). 39. Torque the flange bolt to 59 N·m (79.6 lb-ft). 40. Torque the damper flange bolt to 59 N·m (43 lb-ft). 41. Torque the stabilizer link to 39 N·m (29 lb-ft). 42. Repeat steps 17 thru 41 to install the left damper and spring. 43. Reinstall the trunk side trim panel. 44. Install the brake hose mounting bracket and torque to 22 N·m (16 lb-ft). Reinstall the wheel sensor, and torque the bolt to 9.8 N·m (7.2 lb-ft). 45. Reinstall the wheels, and torque the wheel nuts to 108 N·m (80 lb-ft). HEX WRENCH DAMPER SHAFT DAMPER TRAILING ARM FLANGE BOLT

Buy It at Lowest Price on Amazon

2010 CIVIC 4-DOOR SPORTS SUSPENSION Installation Manual.Pdf

Rating:
2.5 out of 5 by Book123