Book123

Science/Engineering Vol. 2: Metal Lathe

Vol. 2: Metal LatheISBN: 1878087010 | Gingery Publishing, 1980 | 128 pgs | PDF | 1.16 Mb Thank you!thanks a lot

Workholding in the Lathe

Tubal Cain “Workholding in the Lathe" Trans-Atlantic Publications | 1986-06 | ISBN: 0852429088 | 112 pages | PDF | 27,7 Mb

How to Run a Lathe by South Bend Lathe

How to Run a Lathe by South Bend LatheLindsay Publications | 1993 | ISBN: 155918115x | Pages: 128 | PDF | 32.76 MBThe screw cutting engine lathe is the oldest and most important of machine tools and from it all other machine tools have been ...

Getting the Most Out of Your Lathe by Delta Manufacturing

Getting the Most Out of Your Lathe by Delta ManufacturingDelta Manufacturing Co Tool Books - Reprinted by Lindsay Publication Inc | 1997 | ISBN: 1559182008 | Pages: 64 | PDF | 18.03 MBFirst published in the USA in 1935 this comprehensive 64 ...

How to Make 8-Inch Bench Lathe by South Bend Lathe

How to Make 8-Inch Bench Lathe by South Bend LatheLindsay Publications Inc | 2006 | ISBN: 1559183403 | Pages: 64 | PDF | 12.27 MBBack in 1920 when this nifty book was published, South Bend Lathe was only fourteen years old. Yet their lathes ...

Science/Engineering Screwcutting in the Lathe

Martin Cleeve, "Screwcutting in the Lathe" Trans-Atlantic Publications | 1984 | ISBN: 0852428383 | 176 pages | PDF | 127 MB Not all books on / appear on the homepage. In order not to miss many of them follow (see top of each page on ...